When a new bumper assembly occurs, first align the body bumper, using something to stabilize the stability. Check and make sure that the body is flat on each side and that the bumper is absorbed with the body. After making sure they are configured correctly, measure the empty spaces and remove the bumper from your vehicle. Then bring it back.

First, run a 1/8 "flat bar vertically into the deepest channel and separate it into a seam. At the edge of the bottom section, light and stick a vertical strip of the same material. Then form the base by sliding a horizontal flat bar over Each section then drills the holes. Finally close and tighten some nuts in place, first tighten the outer nut, then weld the inner nut, then remove the bolt after loosening the loose nut.

Then, to hold the support bracket, measure and then cut the 1/8 "thick metal plate. Tighten the holes and install them accordingly. Now it is time to fix the bumper and verify its suitability. You can also design and simulate the means on the smart card to verify the effect. With the thickness of the material of 1/8 thickness, arrange the mold and, after spraying the blue, mark it on the sheet. Rotate the driver's side and cut a section corresponding to the angle of the support, then place it with a magnet holder at a 90-degree angle and repeat the procedure on the other side.

Now, cut another plate to fit in the longer section. You will see the side of the small round tube for constipation that will help to hide the fasteners on the stent in the positions of the pins. After welding correctly, you can start the first settings for the bumper and the frame. After the measurement, drill some holes to install and install the bracket with your thumbs.

Select the perimeter of the outer arc on the mounting panel and then remove the assembly. Then, tie them together and tighten them together, through drilled holes that are larger, for better plate penetration. For angles, welding and grinding as well. Sew the metal correctly so that the unit can be strengthened to make it more difficult.

Now use the tube that you just hid all the installations. To place the metal on the opposite support, cuts are provided at the corners, and you can close them completely. After that, you're ready to work on the front bumper. You will notice that the front and rear speakers of the frame are finally open. Therefore, you can try a welded sliding plate with nuts to hold it with the batteries and the weight of the bumper. You can take care

Now, all you require to do is insert the bolt, then tighten the nut before welding so that it can act as a buckle. At this point, you will only need a few stitches. To start threading easily, find some small bolt holes. Drill four holes in the frame, two to secure the screws and the second in the weld, then move the nut in the frame. Then, squeeze them and their flesh instead. Many people will be able to apply these techniques, as described in this article, but some jobs can be done better through a store that specializes in the cane trade.

Finally, it has fronts and is ready to verify the placement. At the same time that the newly created conveyor is installed, install the mounting tube breaks in place on the base plate. Then wrap the metal around the side of the prop posts and fasten it in place. Connect it to the floor, install it and install it only with the case. Repeat this on the back and you can enjoy the look of a beautiful stand that is also characterized by its strength and durability.